Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

Kyocera - Каталог Токарный инструмент 2016 ENG

                                                                    для заказа - kyocera@kyocera-tools.ru

FOR SUCCESSFUL MACHINING WITH KGDF

 Face Grooving Guide                           2) Cutting conditions (Feed rate : f)                                                          AGRADES
                                                                                                                                               B
1) Toolholder Selection                              When machining on steel,                                                                  CINSERTS
      Check the range of applicable                  set the feed rate (f) so                                                                  D
      "face grooving diameter" as                    that chips are created in a                                                               E
      well as the groove width and                   helical form in cut-off.                                                                  F
      depth.                                                                                                                                   G
                                                                                                                                               H
3) How to widen the groove (Plunge machining and Turning)                                                              f                       JCBN & PCD
     Start machining from the outside and then proceed to the inside.                                                                          N
     Chip control will be better in this way.                                                              Traversing                          P
                                                                                                                                               R
            Plunge milling (Grooving + Side grooving)                                                                                          T

                                                                                                                                      G107      TOOLHOLDERS SMALL TOOLS

                                                              f                                                                                 BORING
f

4) Guide for turning                                                                                                                            GROOVING
     A. When the cutting amount (D.O.C.) is
         over 0.020"                                                                                                          (1)               CUT-OFF
         (1) Perform plunging.                                                                                                (2)
                                                                       (2) (1)                                            (3)
         (2) Return the cutting by 0.004".

         (3) Perform turning. (Ref. to Fig.1)

                                                                                                           Fig.1                                THREADING

                                                                       (3)                                                                      HSK TOOLING SPARE PARTS

 When widening the face groove width (Ref. to Fig.2)                                                                     
   Apply the “Step Turning”.
   Then perform finishing.

                                                                                                           Fig.2                                TECHNICAL

B. When the cutting amount (D.O.C.) is                                                                                           (1)  INDEX
   under 0.020"                                                                                                           (2)
   (1) Perform plunging.                                       (2) (1)                                      Fig.3

   (2) Perform turning.                         kyocera@kyocera-tools.ru
                                                   www.kyocera-tools.ru
   Machining without interruption is possible.
   (Ref. to Fig.3)
Заявка