Kyocera - Каталог Токарный инструмент 2016 ENG
для заказа - kyocera@kyocera-tools.ru
CHIPBREAKER SELECTION (NEGATIVE INSERTS)
Steel
1 Molded Chipbreaker
Finishing (With Wiper Edge) Wiper Insert. Finishing GP m Finishing to light
m Double feed rate HQ machining. Good
WP m is available for 0.004” chip control.
finishing to light m Sharp cutting
machining, while Finishing- performance
maintaining a Medium with 3-D rake
smooth finish. m angle and double
projection design.
Finishing-Medium WQ Wiper Insert. Finishing-Medium CQ m
(With Wiper Edge) m Double feed rate Good chip control
possible while at various D.O.C.
maintaining a such as copying.
m smooth finish. Applicable for up-
High efficiency facing.
and good chip
control.
3-step dot Ensures chips will
structure realizes Finishing-Medium m
stable chip control (Up Facing) curl even in small
m at a wide range of depth, high feed
Finishing m m rate machining.
PP CJ
feed rate. Improves chip
Less cutting force
due to sharp evacuation when
copying and up-
cutting edge and facing.
smooth rake face.
Finishing-Medium Stable chip Medium-Roughing Stable machining
control in a wide with a balance of
feed rate range 0.003” edge sharpness
and strength.
PQ m m by breaking chips PG 5° 15° Prevents chip
effectively. clogging at high
The well-balanced feed rates. Good
edge sharpness chip control at
and toughness. low feed rates.
Stable machining
with wide chip
control range.
Applicable Chipbreaker Range (D.O.C. Refers to Radial Depth of Cut)
4UFFM
*$4UFFM
*$4UFFM
*$4UFFM
4UBOEBSE
1( (5 14 )4
82 4UBOEBSE
$PSOFS3 S
(1 *ODMVEJOH%1
$2 14
)4
%0$ JO
%0$ JO
%0$ JO
%0$ JO
12 $+
11
82 $2
81 )2 (4 15
'FFE3BUF JQS
'FFE3BUF JQS
'FFE3BUF JQS
'FFE3BUF JQS
B4 kyocera@kyocera-tools.ru
www.kyocera-tools.ru