Kyocera - Каталог Сверление 2013 ENG

                                    для заказа - kyocera@kyocera-tools.ru

                                                                                               Chamfering Attachment

 Applicable Chamfering Insert                 Description             Dimensions                PVD            Applicable
                                                                            (mm)               Coated           Toolholder
                             Shape                                                             PR0315
                                                                      W1 T                                      S20-CH10
                                                                                                   
                                    CT08T2-45A                        8    2.83                                 S32-CH12
                                                                                                                      ~
                                    CT12T3-45A                        12   3.98                                                                 D r i l l i n g Magic Drill DRC
                                                                                                                S32-CH18
 Method to use DRC chamfering attachment                                                                        : Stock Standard
                                                                                                                  : World Express
1. Drilling depth adjustment
                                                                      2. Drill location check

• Insert drill into chamfering attachment.                            • Rotate the drill so that the lower end of the chamfering insert A
• Next, temporarily attach the chamfering insert A.                    is aligned with the body clearance B of the drill.
• Turn the adjusting screw (1) with the hexagon wrench (4) to set
 the drilling depth T.                                                • Set it so that slot C and the drill fitting screws (2) are lined up as
                                                                       shown in the figure above.

3. Fix the drill                                                      4. Installation of the chamfering insert

• Tighten the drill fitting screws (2) with the hexagon wrench (4).  • Press the chamfering insert A lightly into the drill and tighten the
 (In the case of using a torque wrench, then please refer to the       insert mounting screw (3) with wrench (5).
 table below.)

Chamfering        Torque [Nm] Adjusting Screw  Drill Fitting              Insert Mounting      Hexagon          Wrench
Attachment                                       Screw                          Screw          Wrench             DT-9
 S20-CH10                10 AJ-6X38               FS-10                          MT-3
                         15 AJ-8X44-9.5                                                           LW-3           DT-15
 S32-CH12                20                       FS-12                          MT-4
                         30 AJ-10X46                                                              LW-4
 S32-CH14                45                       FS-14                                           LW-5

 S32-CH16                                         FS-16

 S32-CH18                                         FS-18

                                    kyocera@kyocera-tools.ru                                                                                     44
                                       www.kyocera-tools.ru