Kyocera - Каталог фрезерование 2017 ENG
для заказа - kyocera@kyocera-tools.ru
RAD-6 (MRX)
Ramping Conditions L
Max
• Ramping angle should be under max
D.O.C.
(maximum ramping angle)
in the table below.
• Feed rate should be under 70% of the
cutting conditions on page J18
Inch Metric
Inch Max Max. Metric Max Max.
Tool Spec. Ramping Cutting Tool Spec. Ramping Cutting
Length at Length at
Insert Tool Dia. Max Angle tan Max. Insert Tool Dia. Max Angle tan Max.
0.625 D.O.C. max max Ramping 16 D.O.C. max max Ramping
0.157 0.123 Angle 0.141 Angle
7 4 8
(L) (L)
1.282 28
RD..08 0.750 0.157 9 0.158 0.994 RD..08 20 4 9 0.158 25
1.000 0.157 5 0.087 1.800 25 4 5 0.087 45
0.750 0.197 4 0.070 2.816 20 5 5 0.087 57
1.000 0.197 9 0.158 1.243 25 5 10 0.176 28
1.250 0.197 6 0.105 1.873 32 5 6 0.105 47
RP..10 RP..10
1.500 0.197 4 0.070 2.816 40 5 4 0.070 71
2.000 0.197 3 0.052 3.757 50 5 3 0.052 95
2.500 0.197 2 0.035 5.640 63 5 2 0.035 143
1.250 0.236 9 0.158 1.491 32 6 9 0.158 37
1.500 0.236 6 0.105 2.248 40 6 5 0.087 68
2.000 0.236 4 0.070 3.379 50 6 4 0.070 85
RADIUS / BALL-NOSE RP..12 RP..12
2.500 0.236 2 0.035 6.768 63 6 2 0.035 171
J 3.000 0.236 2 0.035 6.768 80 6 2 0.035 171
4.000 0.236 1 0.017 13.498 100 6 1 0.017 343
1.500 0.315 12 0.213 1.481 40 8 11 0.194 41
2.000 0.315 6 0.105 2.997 50 8 7 0.123 65
2.500 0.315 4 0.070 4.506 63 8 4 0.070 114
RP..16 RP..16
3.000 0.315 3 0.052 6.011 80 8 3 0.052 152
4.000 0.315 2 0.035 9.025 100 8 2 0.035 229
5.000 0.315 1 0.017 17.998 125 8 1 0.017 458
Above value is based on the clearance of 0.039" between the tool and the workpiece.
J20 kyocera@kyocera-tools.ru
www.kyocera-tools.ru