Kyocera - Каталог фрезерование 2017 ENG

ITEMNSE!W                                                                             для заказа - kyocera@kyocera-tools.ru

              MFH-RAPTOR MICRO NEW

               Approximate Programming Radius Adjustment

                                     Drawing                                             Programmable R  Maximum Over Machining of Radius         Maximum Unmachined Portion
                                                                                                  (in)                         (in)                                 (in)

                                                                                         0.039                                      0                                0.0083

                                               Approx. R  MMacahxiinminugmofORvaedr ius         0.047               0                              0.0067
              Mmaaxcimhiunmedupno-rtion                      Over Machined               (Recommended)           0.0032                            0.0039
              Machining Portion                              Radius Portion                                      0.0110                            0.0004
                 Unmachined                                                                     0.059
                 Portion                                                                        0.079

               Ramping                                                                                                                            Cutting Edge Angle: 12°

              Holder                 Cutter Dia.                    0.375"              0.500"          0.625"  8mm         10mm          12mm    14mm    16mm
                                                                                           2.0°            1.2°   4.0°         3.0°          2.0°    1.5°    1.2°
              MFH…-01-…              Max. Ramping                     3.0°                0.035           0.021  0.070        0.052         0.035   0.026   0.021
                                         Angle (°)                   0.052
                                                                                                                                           L
                                       tan  max

              Decrease Ramping Angle if Chips Become Excessively Long

              •	 Recommended ramping angle is  max (see chart above for recommended ramp angle)
              •	 Reduce recommended feed rate by 70%

F  HIGH FEED  Formula for Max.       L=                     D.O.C.
              Cutting Length (L)                          tan  max
              at Max. Ramping Angle

                                                                                                                                            max

                                                                                                                                                           D.O.C.

   F24                                                                                   kyocera@kyocera-tools.ru
                                                                                            www.kyocera-tools.ru