Kyocera - Инструмент для обработки мелких деталей 2016 ENG

                                                                              для заказа - kyocera@kyocera-tools.ru

          Setup (TKN / TK§)GRADES

                1. Tap the insert lightly with a plastic hammer to push it tight enough that it cannot be removed by hand. (Fig.1)INSERTS
A 2. Remove the insert with the supplied wrench. (Fig.2)

B

C  CBN & PCD

E  TURNING                                  Fig.1 How to Attach Inserts                        Fig.2 How to Detach Inserts

                               Recommended Cutting Conditions of CERACUT Cut-Off

                                                     Recommended Grade (Vc sfm)                                                     Width                             Remarks

F WorkpieceBORING                           Cermet          CVD                    PVD         Carbide   1.6mm           2.0~2.4mm         3.1mm       4.1mm
                                                     Coated Carbide         Coated Carbide
                      Material

                                            TN90     CR9025          PR660    PR930            KW10                         Feed Rate (ipr)

                              Carbon Steel                                                 -         0.0008~0.0032   0.0016~0.0071  0.0020~0.0098  0.0032~0.0118
                                            400~650  250~600         200~425  200~425

G Alloy SteelGROOVING                                                                      -         0.0008~0.0032   0.0016~0.0071  0.0020~0.0098  0.0032~0.0118
                                            325~525  225~500         200~425  200~425
                Stainless Steel                                                                -         0.0008~0.0012   0.0016~0.0047  0.0020~0.0071  0.0032~0.0098  Wet
                                                                               
                                            250~500  200~450         175~400  200~450

                              Cast Iron              -                   -                  -           0.0008~0.0032   0.0020~0.0047  0.0039~0.0098  0.0039~0.0118
                                                                                               175~325

                AluminumCUT-OFF                      -                   -                  -           0.0008~0.0039   0.0020~0.0039  0.0020~0.0079  0.0020~0.0098
                                                                                               325~1475
H Brass
                                                     -                   -                  -           0.0008~0.0039   0.0020~0.0039  0.0020~0.0059  0.0020~0.0079
                                                                                               325~650

                                                                                                                             : 1st Recommendation  : 2nd Recommendation

J  SOLID END MILLS THREADING

L

M  MILLING

P  SPARE PARTS

R  TECHNICAL

T  INDEX

   H26                                                                                         kyocera@kyocera-tools.ru
                                                                                                  www.kyocera-tools.ru