Kyocera - Инструмент для обработки мелких деталей 2016 ENG

                                                                                                      для заказа - kyocera@kyocera-tools.ru

                              RECOMMENDED CUTTING CONDITIONS

                               Recommended Cutting Conditions (Vc)

                                                                                      Recommended Insert Grade (Vc : sfm)                                                                               Remarks

A  GRADES                                  Workpiece  Chipbreaker  Cermet   MEGACOAT             Carbide                                     MEGACOAT    CBN      PCD
                                            Material                                                                                             CBN

                                                                    TN90    PR1225   PR1215           GW15                                   KBN05M      KBN570   KPD001

                 Carbon SteelINSERTS                  GM                                                 -                                     -           -         -
                 Alloy Steel                          GL                                                                                          -           -
                                                      CM           325~725  250~650  325~650                -                                     -           -         -                               Wet
B Stainless Steel                                     PH                                                                                          -           -
   CBN & PCD                                          GS                                                 -                                     -           -         -
                 Cast Iron                            PM                                                                                          -           -
                 Aluminum                             GS           250~650  225~600  250~600                -                                                 -         -
                                                      NB                                                                                       
C Brass                                               NB                                                                                                        
                                                                                                                                             250~500
                 Hardened Material                                 225~600  200~500  200~500          650~1650                                    -      325~825  500~6550
                 Powdered Steel                                         -        -
                                                                                                                                                                   
                                                                        -        -
                                                                                     325~650          325~650                                                     650~2625
                                                                        -        -        -                 -                                                           -

                                                                        -        -        -                 -                                                           -

                                                                        -        -        -

                                                                                          -

   TURNING                                                                                                                                    : 1st Recommendation  : 2nd Recommendation

E  Recommended Cutting Conditions (Feed Rate • D.O.C.)                                                                                                  (Workpiece Material : 1049)

                                                          Grooving                                                                           Traversing

F  BORING                     Chipbreaker

G  GROOVING
H GM
J                                                                    : Recommmended feed value

   CUT-OFF

   SOLID END MILLS THREADING  (General
                                 Purpose)

L GLMILLING                   (Low Feed)
M

P PHSPARE PARTS
R
   TECHNICAL                  (High Feed
                                 Rate)

T CMINDEX

             (Copying)

                              1) The above values reflect a T dimension that is 0.669" (17mm) or less.
                              2) If the toolholder is not for the 8mm width insert and its T dimension is over 0.669" (17mm), set the values for longitudinal turning to less than 90% of those above.

   G22                                                                      kyocera@kyocera-tools.ru
                                                                               www.kyocera-tools.ru