Kyocera - Инструмент для обработки мелких деталей 2016 ENG

                                                                    для заказа - kyocera@kyocera-tools.ru

EZ BAR SELECTION / APPLICATION GUIDE

 H ow to Select Bars and Sleeves for Each Application                                                    HP Type Bar + CT/HP Type Sleeve

High Precision              Easy Overhang              Positioning    Cost Reduction                       Excellent repeatability and drastic      GRADES                     A
   Required              Adjustment Required          Not Required        Required                         tool change time reduction

Internal                 Focus on     Focus on                                                                                                      INSERTS                    B
Coolant                  Precision      Cost

  HP Type Bar     HP Type Bar           ST Type Bar     EZ Bar Plus     ST Type Bar                                                                 CBN & PCD                  C
          +               +                     +               +              +                                                                                               E
                                                                                                                                                                               F
CT Type Sleeve  HP Type Sleeve        HP Type Sleeve  HP Type Sleeve  ST Type Sleeve                                                                                           G
                                                                                                                                                                               H
EZH-CT (High precision with coolant hole)                                                                                                           TURNING                    J

Now added in the EZH sleeve Lineup!                                                                                                                 BORING

Kyocera's unique EZ adjust structure and internal coolant system improve dimensional accuracy and surface roughness!

 EZH-CT Applicable Sleeve                             EZH-CT Internal Stucture                                                                    GROOVING

Coolant                                                                                                                                             CUT-OFF
                Coolant
                                                                                                                                                    THREADING SOLID END MILLS
          Coolant Hole

                                      Coolant Hole

 H ow to Set Bar in Sleeve                                                                                                                        MILLING                    L
                                                                                                                                                                               M
    How to use adjustment pin and prevent coolant leakage (Fig.1)                                                                                  SPARE PARTS                P
                                                                                                                                                                               R
          Put the adjustment pin into the hole according to the overhang length and push it into the sleeve using the wrench "LW-1.5".             TECHNICAL                  T
          Tighten the clamp screw for the adjustment pin "HS3x4P" using the wrench "LW-1.5" from both sides of the sleeve.
          Put the additional clamp screws "HS3x4P" into the un-used adjustment pin holes to prevent coolant leakage using the wrench "LW-1.5" and

            fix them from both sides of the sleeve.

    How to secure the bar (Fig.2)

          With the chip pocket upward, set the bar into the sleeve. Press the slant face of the bar end with the adjustment pin.
             Make sure that the bar does not rotate. (Fig.3)

          Tighten the clamp screw with wrench "LW-2" and secure the bar.
             (Use "LW-1.5" if shank dia. is 3mm or less.)

                                                                        

                                                                                                                                                   INDEX

                                   


Fig.1 How to use the adjustment pin                 Fig.2 How to secure the bar

                                                            kyocera@kyocera-tools.ru                       Fig.3 Clamped bar
                                                               www.kyocera-tools.ru
                                                                                                                                                    F13